Digiview Data Display Brightness - Cobra XRS 9700 Operating Instructions Manual

Settings
Your Detector
SmartPower
Your detector includes the SmartPower feature that, when activated,
will put the unit into Standby mode (low power) for about 30 minutes
after the car's engine has been turned off. After 30 minutes in Standby
mode, the unit will automatically turn off.
Before SmartPower enters Standby mode, you will hear one (1) beep and
Pwr Save will appear on the display. To return the unit to normal Power
mode or exit Standby mode, start the car, press any button or turn the unit
off and then on again. The factory setting is SmartPower on.
SmartPower Entering
Standby Mode
Pwr Save
To Turn SmartPower Mode Off Or On Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode,
Tone
go to SmartPower.
One (1) beep
Two (2) beeps
SmartPower Off
...Power off
22 English
Visual Display Voice
SmartPower Off SmartPower Off
SmartPower On SmartPower On
SmartPower On
...Power on
Settings
Your Detector

DigiView Data Display Brightness

Your detector has a Bright display mode (for daytime driving) and three (3)
levels of Dim display modes (Dim for dusk driving, Dimmer for night driving
and Dark where no visual alerts will be displayed) to control the display's
brightness levels. The factory setting is Bright. The factory Dim mode
default setting is Dimmer.
Dark Indicator
.
Select/Dim Button
Press and release
To Change The Brightness To Dim
Press and release the
Tone
Select/Dim button once.
Two (2) beeps
Dim Display Dimmer Display
Dim Dimmer
NOTE
When you change to Dim mode, the unit will enter whichever
dim default mode is set at the time.
To Change The Brightness To Bright
Press and release the
Tone
Select/Dim button again.
One (1) beep
Bright Display
Bright
Visual Display Voice
Dim, Dimmer Dim, Dimmer
or Dark or Dark
Dark Display
Dark
Visual Display Voice
Bright Bright
Nothing comes close to a Cobra ® 23