Audio Alerts; Visual Display; Signals Detected - Cobra XRS 9700 Operating Instructions Manual

Settings
Your Detector
Setting Dim Default
You can set the default level for Dim mode (Dim, Dimmer or Dark)
either in Program mode or directly using the Select/Dim button.
Select/Dim Button
Press and hold
To Set The Display Dim Mode Default Directly Using The Set/Dim Button
Press and hold the
Tone or Voice
Select/Dim button
One (1) beep each time
the display cycles
Release the Select/Dim None
button to select the
current display as
default.
To Set The Display Dim Mode Default Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode,
Tone
go to Display Dim,
Two (2) beeps
Dimmer or Dark.
One (1) beep
One (1) beep
24 English
Dim
Press
and hold
Dark
Select/Dim
button
Dimmer

Visual Display

Cycles — see chart above
Dim, Dimmer or Dark
Visual Display Voice
Dim Dim
Dimmer Dimmer
Dark Dark
Detection
Your Detector
Detection

Signals Detected

The tables on the following pages show you the types of Signals your
detector will detect, as well as the visual alerts it provides for each of them.

Audio Alerts

A distinctly different Alert tone is used for each type of signal detected
(including separate tones for each laser signal). For X, K and Ka band
radar signals, the tones will repeat faster as you approach the signal
source. The repeat rate of the tones gives you useful information about
the signal detected. See responding to alerts on page 28.
Visual Display
An indication of the type of signal detected will appear in the DigiView Data
Display. During X, K and Ka alerts, you will also see from one (1) to five (5)
vertical bars, indicating the strength of the signal detected.
Signal Strength Chart
Signal Strength = 1
(Weakest Signal) Signal Strength = 2
1 2
-
- - -
Signal Strength = 5
Signal Strength = 4 (Strongest Signal)
- _
-
- - -
- - 4 - - - - _ - - - 5
- - - - -
- - - - - - -
- - - -
•
Signal Strength = 3
- - 3
- -
- - -
Nothing comes close to a Cobra ® 25