Pop Alert - Cobra XRS 9700 Operating Instructions Manual

Settings
Your Detector
Select/Dim Button
Program/Mute Button
To Calibrate The Compass Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode, go to
Set Compass.
Press and hold the Set/City button
to begin setting the compass.
Within two (2) minutes, drive your
vehicle in a circle twice, then press
the Set/City button again.
Press and release either the Select/Dim
button to proceed to the next user
mode or the Program/Mute button
to exit Program mode.
Set Compass
Set Compa...
NOTE
If you do not press the Set/City button within two (2) minutes after beginning
the set compass process, compass calibration will automatically terminate.
Tone Visual Display Voice
One (1) beep Compass not set... Compass not set...
Please try again... Please try again...
18 English
Set/City
Button
Tone Visual Display Voice
None Set Compass None
One (1) beep Drive in 2 Set Compass
circles...
Press SET
when done...
Three (3) Compass Set! Compass Set
beeps For two (2)
seconds
followed by
direction of
travel (N, NE,
E, SE, S, SW,
W or NW)
None None None
Calibrate Direction
Compass Compass Set Of Travel
Drive in... Compass N W
Press SET... Set!
Terminate
Compass n...
Please tr...
Your Detector

Pop Alert

Pop Alert will alert you of Pop radar signals. During the alert, the unit
continues to detect other signals. The factory setting is Pop Detect off.
To Turn Pop Detect Mode On Or Off Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode,
go to Pop Detect.
h
Settings
Tone Visual Display
Two (2) beeps Pop On
One (1) beep Pop Off
Pop Detect On Pop Detect Off
Pop On Pop Off
Nothing comes close to a Cobra
Voice
Ka Pop On
Ka Pop Off
® 19