Settings; Highway/City Mode; Digiview Data Display Brightness - Cobra XRS 950 Operating Instructions Manual

Settings

Your Detector
Intro Operation Customer Warranty
Settings
Assistance
When changing the Settings on your detector, please keep in mind:
Buttons can have multiple functions.
n
Depending on your choice of Voice Alert or Tone Alert mode, you will
n
Secondary Icons
hear either voice messages or tones confirming changes in settings.
All settings will be stored in memory when the power is
n
turned Off and recalled when the power is turned back On.

Highway/City Mode

Notice
Setting your detector to City mode delays all X band audio alerts until
the signal strength reaches Level 3. (A single beep will sound when the
signal is first detected.) This will reduce false alerts while you are driving
in, or near, urban areas where there are many sources for conflicting
X band signals such as microwave towers and automatic door openers.
To change settings, follow the procedure listed below, which indicates
what you will see and hear (either in Voice Alert or Tone Alert mode)
as you complete each step. The factory setting is Highway mode.
Highway Mode
h
City Mode
c
To Change From Highway Mode to City Mode
Press and release
Tone
the City button.
One beep
To Change From City Mode Back to Highway Mode
Press and release
Tone
the City button again.
Two beeps
English
6
•
City Button
Press and
release
Voice
Visual Display
City blinks, then c appears
City
in the display
Voice
Visual Display
Highway blinks, then h
Highway
appears in the display
Settings
Your Detector
Intro Operation Customer Warranty

DigiView Data Display Brightness

Assistance
You can choose from four (4) settings for Brightness
of the display. You can cycle through the settings by
repeatedly pushing the Dim button. The factory
setting is Bright.
Secondary Icons
Notice
Dim Button
Press and
release
To Change the Brightness to Dim
Press and release
Tone
the Dim button
One beep
once.
To Change the Brightness to Dimmer
Press and release
Tone
the Dim button
One beep
again.
To Change the Brightness to Dark
Press and release
Tone
the Dim button
One beep
a third time.
To Change the Brightness to Bright
Press and release
Tone
the Dim button a
Two beeps
fourth time.
Bright
Press and
Dim
Dark release
Dim button
Dimmer
Dark Indicator
.
Voice
Visual Display
Dim Dim blinks, then
display dims
Voice
Visual Display
Dimmer Dimmer blinks, then display
dims further
Voice
Visual Display
Dark Dark blinks, then display
goes dark (no visual alerts
will be seen)
Voice
Visual Display
Bright Bright blinks, then display
returns to full brightness
Nothing Comes Close to a Cobra
®
7