Table of Contents
Advertisement
EasySet Programming
Your Detector
EasySet Programming
All user mode settings on your detector can be changed by using
Program mode. When changing the settings, please keep in mind:
Buttons can have multiple functions.
All settings will be stored in memory when the power is
turned off and recalled when the power is turned back on.
The procedure for using Program mode is shown on page 7.
NOTE
You cannot enter Program mode during an alert. The unit will not detect
signals while in Program mode. During programming, if no buttons are
pushed for ten (10) seconds, the unit will automatically exit Program
mode and save the last settings.
Programming User Modes
The tables on pages 8 through 9 show you how to program all user modes
and the settings you can choose from.
NOTE
On the following pages, you will find more detailed
explanations of each setting.
See page 15 for instructions on setting the IntelliMute activation point.
See page 17 for instructions on calibrating the compass.
See page 22 for instructions on using SmartPower.
English
6
EasySet Programming
Your Detector
Set/City Button
•
Press and release
Select/Dim Button
Press and release
Press and hold/Press and release
To Use Program Mode
Press and hold the
Program/Mute button
for two (2) seconds.
While the programming
instructions are
scrolling, press and
release the Select/Dim
button to cycle through
the user modes.
With the user mode you
wish to change displayed,
press and release the
Set/City button to
change the setting.
To move to the next
selection, press the
Select/Dim button again.
When you have finished
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten (10)
seconds without
pushing any buttons.
Program/Mute Button
Tone
Visual Display
Three (3)
Program will appear.
beeps
PROGRAM
Then brief programming
instructions will scroll
through the display three
(3) times.
One (1) beep
As each mode is displayed,
with each
the current setting for that
button press
mode will be shown.
One (1)
The setting you
or two (2)
select will be shown.
beeps,
depending
on your
selection
One (1) beep When you exit Program
mode, the new setting
will automatically be saved
and EXIT PROGRAM and
Settings Saved! will appear.
EXIT
Settings
PROGRAM
Saved!
Nothing comes close to a Cobra
Voice
Start Program
None
Current
setting
Exit Program
®
7
Hide quick links:
Advertisement
Table of Contents
