Smartpower; Digiview Data Display Brightness - Cobra XRS 9730 Operating Instructions Manual

9496 XRS 9730-D-B2 4/10/06
Settings
Your Detector

SmartPower

Your detector includes the SmartPower feature that, when activated, will put the
unit into Standby mode (low power) for about 30 minutes after the car's engine
has been turned off. After 30 minutes in Standby mode, the unit will automatically
turn off.
Before SmartPower enters Standby mode, you will hear
SmartPower Entering
Standby Mode
one beep and Pwr Save will appear on the display. To
return the unit to normal Power mode or exit Standby
Pwr Save
mode, start the car, press any button or turn the unit off
and then on again. The factory setting is SmartPower on.
To Turn SmartPower Mode On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, Tone Visual Display
go to SmartPower.
Two beeps SmartPower On
One beep SmartPower Off
SmartPower On
...Power On
22 English
12:01 PM Page 22
Voice
SmartPower On
SmartPower Off
SmartPower Off
...Power Off
Settings
Your Detector

DigiView Data Display Brightness

Your detector has a Bright display mode (for daytime driving) and three levels
of Dim display modes (Dim for dusk driving, Dimmer for night driving and
Dark where no visual alerts will be displayed) to control the display's
brightness levels. The factory setting is Bright. The factory Dim mode
default setting is Dimmer.
Dark Indicator
.
Select/Dim Button
Press and release
To Change the Brightness to Dim
Press and release the
Tone Visual Display
Select/Dim button once.
Two beeps Dim, Dimmer
or Dark
Dim Display Dimmer Display Dark Display
Dim Dimmer Dark
NOTE
When you change to Dim mode, the unit will enter whichever
dim default mode is set at the time.
To Change the Brightness to Bright
Press and release the Tone Visual Display
Select/Dim button again.
One beep Bright
Bright Display
Bright
Nothing Comes Close to a Cobra
Voice
Dim, Dimmer
or Dark
Voice
Bright
® 23