Settings
Your Detector
SmartPower
Your detector includes the SmartPower feature that, when activated, will put
the unit into Standby mode (low power) for about 30 minutes after the car's
engine has been turned Off. After 30 minutes in Standby mode, the unit will
automatically turn Off.
SmartPower Entering
Before SmartPower enters Standby mode, you will hear one
Standby Mode
beep and Pwr Save will appear on the display. To return
the unit to normal Power mode or exit Standby mode, start
Pwr Save
the car, press any button or turn the unit Off and then On
again. The factory setting is SmartPower On.
To Turn SmartPower Mode On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
Tone
go to SmartPower.
Two beeps
One beep
...Power On
22 English
Visual Display
SmartPower On
SmartPower Off
...Power Off
Settings
Your Detector
DigiView Data Display Brightness
Your detector has a Bright display mode (for daytime driving) and three
levels of Dim display modes (Dim for dusk driving, Dimmer for night driving
and Dark where no visual alerts will be displayed) to control the display's
brightness levels. The factory setting is Bright. The factory Dim mode
default setting is Dimmer.
Dark Indicator
.
To Change the Brightness to Dim
Press and release the
Tone
Select/Dim button once.
Two beeps
Dim Display
Dimmer Display
Dim
Dimmer
NOTE
When you change to Dim mode, the unit will enter
whichever dim default mode is set at the time.
To Change the Brightness to Bright
Press and release the
Tone
Select/Dim button again.
One beep
Bright Display
Bright
Select/Dim
Button
Visual Display
Dim, Dimmer or Dark
Dark Display
Dark
Visual Display
Bright
Nothing Comes Close to a Cobra
®
23