Table of Contents
Advertisement
2. Bin Control Installation
1) Remove the control box cover. Remove
the 2 thumbscrews securing insulation
panel (B), then remove insulation panel (B).
See Fig. 3.
2) Disconnect the discharge hose from the
pump motor, then disconnect the drain
valve drain hose and the overflow drain
hose.
3) Disconnect the pump motor connector from
the back of the control box, then disconnect
the float switch connector from the control
board.
4) Remove the tape securing the bin control.
5) Remove the 2 thumbscrews securing the
pump motor and float switch assembly. See
Fig. 4.
6) Being careful not to pull the bin control
cable, lift the bin control up out of the water
tank. Being careful not to snag the bin
control or bin control cable, slide the water
tank, cube guide, and pump motor and float
switch assembly out of the icemaker.
7) Secure the bin control to the rear interior wall using the 2 thumbscrews on the rear
interior wall. Route the bin control cable vinyl hose through the grommet as illustrated.
Do not leave any slack in the ice drop zone. See Fig. 5.
8) Replace the water tank, cube guide, and pump motor and float switch assembly in their
correct positions.
9) Secure the pump motor and float switch assembly with the 2 thumbscrews.
10) Reconnect the hoses.
11) Reconnect the pump motor connector and the float switch connector.
12) Replace insulation panel (B) in its correct position and secure with the 2 thumbscrews.
13) Replace insulation panel (A), the top insulation, the control box cover, and the exterior
panels in their correct positions.
Fig. 5
Thumbscrews
Bin Control
Rear Interior Wall
14
Bin Control Cable
Tape
Drain Valve
Drain Hose
Bin
Discharge
Control
Hose
Fig. 3
Bin Control Cable
Bin Control
Water Tank
Fig. 4
Float Switch
Connector (Black)
Pump Motor
Connector
Thumbscrews
Insulation
Overflow
Panel (B)
Drain Hose
Thumbscrews
Pump Motor
and Float
Switch
Assembly
Cube Guide
Bin Control Cable
Grommet
Vinyl Hose
Advertisement
Table of Contents
