Table of Contents
Advertisement
2. Bin Control Installation
Before operating the icemaker, the bin control must be installed. Failure to properly
install the bin control could result in ice backup and icemaker damage.
Follow the instructions below for bin control assembly installation.
1) Remove the front panel.
2) Remove the bin control insulation and bin control cover. See Fig. 6.
3) Remove the bin control from the bin control cover.
4) Remove the bin control extension bracket and 2 thumbscrews from the accessory bag.
Route the bin control cable around one of the notches on either side of the extension
bracket, then secure the bin control to the bin control extension bracket using the
2 thumbscrews. See Fig. 7.
Note: All thumbscrews used in the bin control assembly are the same size.
5) Using 2 existing thumbscrews, attach the bin control extension bracket to the bin control
cover.
6) Route the bin control cable through the slot in the bin control cover, then place the bin
control assembly into position and secure with 2 existing thumbscrews.
7) Replace the bin control insulation in its proper position.
Fig. 6
NOTICE
Bin Control Insulation
Bin Control
Cover
Bin
Control
14
Bin Control Extension Bracket
and 2 Thumbscrews from
Accessory Bag
Bin Control
Fig. 7
Bin Control Insulation
Slot
Notch
Bin
Control
Cover
Advertisement
Table of Contents
