Pioneer XDV-P9 Service Manual page 70

XDV-P9
3. Move to the ELV/tray selection mode and press one key to select the ELV mode.
4. Move to the operation mode selection.
5. Press key 1 to set maximum movement.
Note) At default, intermediate movement is set.
For maximum movement, while the key 1 is being pressed,
the stage mechanism unit section continues moving.
For intermediate or minimum movement, whenever the
BAND key is pressed once, the stage mechanism
section moves.
6. Move to the motor forward revolution mode or motor reverse revolution
mode and align the magazine slot to graduations on the fourth disc (Fig. 1).
7. Adjustment
Adjust the potential difference between EREF and EPVO of PCB (B)
to 380 ± 20 mV with VR302.
8. Termination of adjustment
Move to the mechanism-unit test termination mode and terminate
the mechanism-unit test mode.
9. Operation check
Terminate the test mode.
Place the mechanism unit horizontally (set the main unit to the drop side). At this time, take care of
short-circuiting of the PCB.
10. Check the height of the stage.
Press the DISC ± key to select DISC 4.
Check that the stopper bend of the clamping lever is fitted in the groove of the frame stopper
section. (Fig. 2 to 4)
• Precautions
• The stopper bend to be clamped finally is clamped under the groove. Check the stopper bend at
the position where it is fitted in the groove.
• Adjustment is completed if the stopper bend enters the center and is clamped under the groove.
• If the stopper bend is dislocated, check misalignment.
70
The amount of movement
changes each time key 1 is
pressed.
maximum movement
i
Key 1
i
intermediate movement
i
Key 1
Key 1
i
minimum movement
i
Forward
revolution
Reverse
revolution
Go to 11).
Display on head unit
7 0 4 1 0 0 0 0
0 0 0 0 0 0 0 0
ELV
Tray 0 0 0 0 0 0 0 1
7 0 4 2 0 0 0 0
0 0 0 0 0 0 0 1
0 0 0 0 0 0 0 2
0 0 0 0 0 0 0 0
7 0 4 3 0 0 0 0
7 0 4 4 0 0 0 0
7 0 4 5 0 0 0 0
Go to 14).