Table of Contents
Advertisement
6.2 DESTINATION SETTING
When replacing the FLASH MEMORY (IC1004) on the Main unit or Main unit, please set as follows.
When the following setting is done once, you cannot change setting again.
When you mistake setting, please replace the FLASH MEMORY(IC1004) again.
- Set object destination model
1.EW
2.ES/RC
3.ES/RD
- Preparation
1.Remote controller "GGP1011" for debug mode
2.Remote controller for XDV-P9
3.Magazine
4.Monitor TV
- Method
1. Insert an empty magazine in this machine, and turn on the power.
(The following destination codes set screens are displayed)
[Players : * * * * * setting]
< 1 > : * * * * * 1
< 2 > : * * * * * 2
< 5 > : * * * * * 5
Pick out any of there!
*The above-mentioned screen is for EW example of the display. (The number of the selection of the destination code
display changes described in the under mentioned clause 2 when ES/RC and RD)
*Actually, the character is displayed above-mentioned ******.
2. Please select the destination code (2-4 keys) by the remote controller of GGP1011.
(1) EW
: setting 2 Push "2" key from among the display of the selection number of 1, 2, and 5.
(2) ES/RC : setting 3 Push "3" key from among the display of the selection number of 1, 3, and 6.
(3) ES/RD : setting 4 Push "4" key from among the display of the selection number of 1, 2, 4,and 5.
3 Open the door, push the "EJECT" button, and turn off the power.
The destination code selected in clause 2 will be written in FLASH MEMORY by doing this operation.
4. Turn off the power.
5. Set DVD DISC sold in the region which corresponds to this machine in the magazine.
And, insert the magazine in this machine, and confirm whether it is possible to play.
There is a possibility of mistake of setting in clause 2 if unplayable.
In that case, please replace FLASH MEMORY(IC1004), and do setting over again from the clause 1.
XDV-P9
65
Advertisement
Table of Contents
