Docking board (models without a hard drive)
Description
Docking board (models without a hard drive)
Before disassembling the dock, follow this step:
▲
Remove the bottom cover (see
Remove the docking board:
1.
Disconnect the keyboard cable from the docking board (1).
2.
Disconnect the touchpad cable from the docking board (2).
3.
Remove the two Phillips PM2.0×2.0 screws (3) that secure the board to the doc.
4.
Remove the docking board from the dock (4).
Reverse this procedure to install the docking board.
Bottom cover on page
40).
Spare part number
902371-001
Dock component replacement procedures
45