Hard Drive And Hard Drive Connector Board - HP 255 G6 Maintenance And Service Manual

Hard drive and hard drive connector board

NOTE: The hard drive spare part kit does not include the hard drive bracket, cable, or connector board.
Description
Hard drives:
1-TB, 5400-rpm
500-GB, 7200-rpm
500-GB, 5400-rpm
Hard drive bracket
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
To remove the hard drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the hard drive assembly to the computer.
2. Lift the rear of the hard drive upward (2).
Battery on page 30).
Optical drive on page
Bottom cover on page
31), if installed.
38).
Component replacement procedures
Spare part number
778192-005
703267-005
778186-005
924980-001
45