Figure 5-45: Advanced Mode - New Aggregate Policer - Linksys SRW2008 User Manual

WebView Switches
Match. Criteria used to match IP addresses and /or MAC addresses with an ACL's address.The possible field
values are:
• And. Both the MAC-based and the IP-based ACL must match a packet.
• Or. Either the MAC-based or the IP-based ACL must match a packet.
MAC ACL. Matches packets to MAC based ACLs first, then matches packets to IP based ACLs.
Police. Enables Policer functionality.
Type. Policer type for the class. Possible values are:
Aggregate Policer. Configures the class to use a configured aggregate policer selected from the drop-down
menu. An aggregate policer is defined if the policer is shared with multiple classes. Traffic from two different
ports can be configured for policing purposes. An aggregate policer can be applied to multiple classes in the
same policy map, but cannot be used across different policy maps.
Single. Configures the class to use manually configured information rates and exceed actions.
Aggregate Policer. User-defined aggregate policers.
Aggregate Policer Settings. The Aggregate Policer button opens the New Aggregate Policer screen.
New Aggregate Policer screen
Aggregate Policer Name. Enter a name in this field.
Ingress Committed Information Rate (CIR). Defines the CIR in bits per second. This field is only relevant when
the Police value is Single.
Ingress Committed Burst Size (CBS). Defines the CBS in bytes per second. This field is only relevant when the
Police value is Single.
Exceed Action. Action assigned to incoming packets exceeding the CIR. This field is only relevant when the
Police value is Single. Possible values are:
• Drop. Drops packets exceeding the defined CIR value.
• Remark DSCP. Remarks packet's DSCP values exceeding the defined CIR value.
• None. Forwards packets exceeding the defined CIR value.
Chapter 5: Using the Web-based Utility for Configuration
QoS Tab - Advanced Mode

Figure 5-45: Advanced Mode - New Aggregate Policer

63