IBM IntelliStation M Pro Hardware Maintenance Manual page 69

Preinstallation steps
Some of these steps are required only the first time you install a hard disk drive in a
specific bay.
1. Review the safety information beginning on page 129, "Installation guidelines"
on page 31, and the documentation that comes with your drive.
2. Verify that you have all the cables and other equipment specified in the
documentation that comes with the drive.
3. Choose the bay in which you want to install the drive.
4. Check the instructions that come with the drive to see if you need to set any
switches or jumpers on the drive. If you are installing a SCSI device, be sure to
set the SCSI ID for that device.
Installing a drive in bay 2 or 4
Complete the following steps to install a drive in bay 2 or 4:
1. Follow the instructions in "Preinstallation steps" on page 59.
2. Turn off the computer and all attached devices.
3. Disconnect all external cables and power cords; then, remove the side cover
(see "Removing the side cover" on page 52).
4. Remove the support bracket (see "Removing and installing the support
bracket" on page 53).
59
Installing options