Installing A Security Rope Clip - IBM IntelliStation M Pro Hardware Maintenance Manual

11. Insert the DIMM into the connector. Firmly press the DIMM straight down into
12. If you have other options to install or remove, do so now.
13. Push the drive cage outward and press in on the drive-cage release tab; then,
14. Replace the support bracket (see "Removing and installing the support
15. Replace the side cover (see "Replacing the side cover" on page 67).
16. Reconnect the external cables and power cords. Turn on the attached devices,

Installing a security rope clip

To help prevent hardware theft, you can add a security rope clip and cable to your
computer. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the computer.
Before you begin, obtain the following items:
v A flat-blade screwdriver
v An adjustable wrench
v A 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing No.
v Threaded nuts that fit the rope clip
v A security cable
v A lock, such as a combination lock or padlock
66
IBM IntelliStation M Pro Types 6220 and 6230: Hardware Maintenance Manual
the connector by applying pressure on both ends of the DIMM simultaneously.
The retaining clips snap into the locked position when the DIMM is firmly
seated in the connector. If there is a gap between the DIMM and the retaining
clips, the DIMM has not been correctly installed. Open the retaining clips,
remove the DIMM; then, reinsert it.
DIMM
connector 1
rotate the cage back into the computer.
bracket" on page 53).
and turn on the computer.
3230, Stock No. 176-735)
DIMM
connector 2
DIMM
connector 3
DIMM
connector 4