Product Features - GEM AD500 Instruction Manual

Automatic Door Operator
2
Manual
Make sure to identify whether the door swing direction is inswing or outswing before installing the door
operator. Use the push arm attachment for outswing doors and the sliding arm and track assembly for
inswing doors.
Outswing

3. Product Features

Operating voltage: 100~240 VAC
Door weight range: 50~150 kg
Four modes of operation: Auto Mode/ Hold Mode/ Manual Mode/ Push Mode
Obstruction detection - If the door is obstructed during operation, the operator will stop the door
and reverse movement
Backup battery input for emergency power supply
Operates with infrared safety sensors, wall push buttons, card readers, or radio frequency devices
Adjustment of hold-up time, opening/closing speed, and opening angle
Easy integration with electric locking devices and access control systems
The AD500 automatic door operator uses a DC motor to open the door. It closes the door by motor
and spring force.
When an opening signal is received by the control unit, the door is opened at the operator-adjusted
opening speed until it reaches the back check position, where it decelerates to a slower speed.
Push arm
Opening Cycle
Hold Open Position
Deceleration
To Fully Opened
Back Check
Opening Speed
Inswing
Closing Cycle
Closing Speed
Latch Check
Deceleration To Fully Closed
Sliding arm
Track assembly