GEM AD500 Instruction Manual page 28

Automatic Door Operator
26
Manual
11-3 Fasten the arm to the operator
body using the pivot post.
11-5 Assemble the track assembly
and sliding arm.
11-7 Use the track block to adjust the opening
angle if necessary.
The track block is used for setting the maximum door
opening angle.
If the opening angle is not wide enough, then loosen
with an Allen key to adjust to the desired angle and
restart "Learning Mode" again.
11-4 Open the door such that the arm is at 90
degrees and check the leveling per shown
below and adjust leveling accordingly.
11-6 Put the track block into the track assembly.
Place the block with the black rubber side facing
the track assembly. The track block installation is
up and down rever
Hex Bolt
Track
Block
Plate
Track
Block
Hex Bolt
Track
Block
Plate
Black
Black
Rubber
Rubber
Track
Block