Table of Contents
Advertisement
12. Learning Mode
1. After turning on power, D17/D18 LED on the board both light on and off indicating the motor is
energized and proceeds to "Learning Mode".
2. Press the exit button on the operation controller, the Automatic Door Operator first activates and
proceeds with the Learning Mode.
3. The Learning Mode establishes the regular operation procedure by learning the environmental factors
such as door leaf weight or opening angle.
4. If obstruction occurs during the Learning Mode such as warped frames or misaligned doors, the motor
force increases, allowing the door to move forward.
5. Depending on the door size or weight and wind pressure, adjust the SVR1 (back check angle), SVR2
(closing speed) and SVR3 (opening speed) to the optimal condition.
6. Adjust the hold-open time (3/10/20/30 seconds) by using DIP switch on the PC board.
7. Install the cover and pivot arm plug to complete installation.
Large
Small
SVR 1
Fast
Slow
SVR 3
13. Operation Controller
Use with control box for ease of operation.
Opening Cycle
Hold Open Position
Opening Speed
Auto Mode:
Press the exit button.
The Automatic Door Operator opens and closes automatically.
Hold Mode:
Press the exit button.
The Automatic Door Operator holds the door open.
For heavy traffic, the Automatic Door Operator changes to Auto
operation allowing the door to close.
Manual Mode:
Power to the Automatic Door Operator is turned off.
The Automatic Door Operator is used as a manual door closer.
Push Mode:
Push the door slightly and then Automatic Door operator is in Auto
Mode.
When in Push Mode, the electric lock remains unlocked.
Fast
Slow
SVR 2
Large
Small
SVR 1
Automatic Door Operator
27
Manual
Closing Cycle
Closing Speed
Advertisement
Table of Contents
