Lexmark X940E User Manual page 139

Menu item
Timeouts
Standby Mode
Disabled
2–240
Timeouts
Power Saver Mode
Disabled
2–240
Timeouts
Screen Timeout
15–300
Timeouts
Print Timeout
Disabled
1–255
Timeouts
Wait Timeout
Disabled
15–65535
Timeouts
Network Job Timeout
1–255
Description
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 minutes is the factory default setting.
Specifies the number of minutes of inactivity before some
systems begin entering a minimum power state.
Notes:
•
60 minutes is the factory default setting.
•
Power Saver does not interact with Standby Mode.
•
Changing Power Saver should not cause Standby Mode
to be changed.
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Sets the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the remainder of the
print job
Notes:
•
90 seconds is the factory default setting.
•
When the timer expires, any partially printed page still in
the printer is printed, and then the printer checks to see if
any new print jobs are waiting.
•
Print Timeout is available only when using PCL or PPDS
emulation. This setting has no effect on PostScript
emulation print jobs.
Sets the amount of time in seconds the printer waits for
additional data before canceling a print job
Notes:
•
40 seconds is the factory default setting.
•
Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL or
PPDS emulation print jobs.
Sets the amount of time in seconds that a network print job can
take before it is canceled
Notes:
•
90 seconds is the factory default setting.
•
A setting value of 0 disables the timeout.
•
If a value of 1–9 is selected, the setting will be saved as
10.
139