LevelOne CamCon FCS-1060 User Manual page 70

IP CamSecure
Config
Setting - I/O Device
Module Setting
List of devices
Input Monitor
Module Setting: Name the module device and ID that has been connecting the digital input/output
device(s) to your system.
Device: This column displays the device(s) already installed to the system.
ID: Select the number of the I/O port to which you plug the ribbon cable.
Input Monitor: The device(s) is turned on if the dot is in red. By triggering the digital input device,
the related icon will light up. This is used to check if the device is correctly connected or not.
Output Monitor: The device(s) is turned on if the dot is in red. By clicking on the icon, you may
trigger the digital device connecting to the system. This can be used to test if the output device is
correctly connected.
Device Setting
Name: Insert the name of the device (input and output).
Type: Select the device type from the drop-down menu. N/O represents that the digital signal is
on in normal condition; N/C represents that the signal is off in normal condition.
Device Setting
69
Output Monitor