Triumph Scrambler 1200 XC Owner's Handbook Manual page 70

General Information
Models with Daytime Running Lights
(DRL)
If the DRL switch is in the Daytime
Running Lights (DRL) position, then
press and hold the high beam button
to turn the high beam on. It will remain
on as long as the button is held in and
will turn off as soon as the button is
released.
If the DRL switch is in the dip beam
position, press the high beam button to
switch the high beam on. Each press of
the button will swap between dip and
high beam.
Note
A lighting on/off switch is not installed
on this model. The brake/tail light
and license plate light all function
automatically when
turned to the ON position.
The headlight will function when the
ignition is turned on and the engine is
running.
Models without Daytime Running Lights
(DRL)
Press the high beam button to switch
the high beam on. Each press of the
button will swap between dip and high
beam.
Note
A lighting on/off switch is not installed
on this model. The position light, brake/
tail light and license plate light all
function automatically when the ignition
is turned to the ON position.
The headlight will function when the
ignition is turned on and the engine is
running.
70
the ignition is
Cruise Control
Warning
Cruise control must only be used
where you can ride safely at a steady
speed.
Cruise control should not be used
when riding in heavy traffic, on roads
with sharp/blind bends or when they
are slippery.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result
in loss of motorcycle control and an
accident.
Warning
This Triumph motorcycle should be
operated within the legal speed limits
for the particular road traveled.
Operating a motorcycle at high speeds
can be potentially dangerous since the
time available to react to given traffic
situations is greatly reduced as road
speed increases.
Always reduce speed in potentially
hazardous driving conditions such as
bad weather or heavy traffic.