Triumph Scrambler 1200 XC Owner's Handbook Manual page 68

General Information
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the daytime running lights
when dark, in tunnels or where poor
ambient light is apparent may reduce
the riders vision or blind other road
users.
Blinding other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
Note
During daylight hours the daytime
running lights improve the motorcycles
visibility to other road users.
Low beam headlights must be used
in any other conditions unless the
road conditions allow for high beam
headlights to be used.
MODE Button
When the MODE button is pressed and
released it will activate the Riding Mode
Selection Menu in the display screen.
Further presses of the MODE button
will scroll through the available riding
modes, see Riding Mode Selection on
page 36.
Press and hold the MODE button when
a riding mode is selected provides
direct access to the riding mode's
configuration menu.
For more information on riding mode
selection and
page 47.
68
configuration, see
Turn Signals Switch
When the turn signal switch is pushed
to the left or right and released, the
corresponding turn signals will flash
on and off. To turn off the turn signals,
push and release the switch in the
central position.
There are three turn signals options:
Auto Basic - The self-canceling
•
function is on. The turn signals will
activate for eight seconds and an
additional 65 meters.
Auto Advanced - The self-canceling
•
function is
activates the turn signals for three
flashes. A longer press activates the
turn signals for eight seconds and
an additional 71 yards (65 meters).
Manual - The self-canceling function
•
is off. The turn signals must be
manually canceled using the turn
signal switch.
To select a turn signal option, refer to
the Bike Setup section on page 50.
The turn signals can be canceled
manually. To manually turn off the turn
signal, press and release the turn signal
switch in the central position.
Joystick Button
The Joystick is used to operate the
following functions of the instruments:
• Up - scroll the menu from the
bottom to the top
• Down - scroll the menu from the top
to the bottom
• Left - scroll the menu to the left
• Right - scroll the menu to the right
• Center - press to confirm selection.
on. A short press