Drive Chain And Sprocket Wear Inspection - Triumph Scrambler 1200 XC Owner's Handbook Manual

Drive Chain and Sprocket Wear
Inspection
Warning
Never neglect drive chain maintenance
and always have drive chains installed
by an authorized Triumph dealer.
Use a genuine Triumph supplied drive
chain as specified in the Triumph Parts
Catalog.
The use of non-approved drive chains
may result in a broken drive chain or
may cause the drive chain to jump
off the sprockets leading to loss of
motorcycle control or an accident.
If the sprockets are found to be worn,
always replace the sprockets and drive
chain together.
Replacing worn sprockets without also
replacing the drive chain will lead to
premature wear of the new sprockets.
1. Measure across 20 links
2. Weight
Caution
1
2
10-20
KG
Maintenance and Adjustment
To inspect the drive chain and sprocket
wear:
• Remove the drive chain guard.
• Stretch the drive chain taut by
hanging
weight on the drive chain.
• Measure the length of 20 links on
the straight part of the drive chain
from pin center of the 1st pin to the
pin center of the 21st pin. Since the
drive chain may wear unevenly, take
measurements in several places.
• If the length exceeds the maximum
service limit of 12.6 in (320 mm), the
drive chain must be replaced.
• Rotate the rear wheel and inspect
the drive chain for damaged rollers,
and loose pins and links.
• Also inspect
unevenly or excessively worn or
damaged teeth.
a 20 - 40 lb (10 - 20 kg)
the sprockets for
131