Electrical Connection - Asko DC7784HP.W.AU User Manual

ELECTRICAL CONNECTION

The drying cabinet must be connected
to a 230V single-phase 50Hz and
protectively earthed wall socket.
The drying cabinet is supplied ready for
connection with a cable and an earthed
plug.
The drying cabinet should be
connected to an earthed wall socket
using the connecting cable supplied
and must not be permanently wired.
The socket should be located so that
the plug can be easily pulled out if
necessary.
Check that the connection current
agrees with the data on the
identifi cation plate and that the
power cord is earthed correctly in
accordance with applicable standard.
We recommend that the power
cord be fi tted with a residual current
device (RCD).
The drying cabinet should be
connected to a dedicated circuit.
Electrical connection of the appliance
should comply with applicable
electrical safety regulations.
18
859149au_en.indd 18 859149au_en.indd 18
The manufacturer cannot be held
liable if the electrical connections are
not carried out as prescribed in this
manual.
If the power cord for any reason is
damaged, it must be replaced. A
genuine part can obtained from the
cabinet dealer. A replacement cord
may only be installed by a qualifi ed
electrician.
17. 02. 2022 08:51:23 17. 02. 2022 08:51:23