Electrical Requirements; User Liability; Electrical Connection - Asko DC7583 Operating Instructions Manual

Electrical requirements

User liability

It is the responsibility of the user to contact a
qualified electrician if a power outlet as described
in this manual is not available.
WARNING!
• Connect to a power outlet with a protective
earth.
• Do not disconnect the earth connection.
• Do not use an adapter.
• Do not use an extension cord.

Electrical connection

• Connect to an individual branch circuit.
Minimum 16 AWG required and 15 amps
overcurrent-protective device.
• The drying cabinet is to be connected to 120V,
1-Phase, 60Hz, and a protective power outlet.
The power outlet must be installed and earthed
in compliance with applicable regulations.
• The drying cabinet is delivered ready for
connection with a 79" (2 m) long cable with an
earthed plug.
• Do not change the cable and plug supplied
with the drying cabinet. If the plug does not fit
the power outlet, this must be rectified by a
qualified electrician.
• The drying cabinet must be connected using
the supplied connection cable and must not
be permanently connected!
• The power outlet must be positioned so that
the plug can be unplugged when necessary.
• As standard, the connection cable is drawn
out from the rear of the drying cabinet. If
necessary, the connection cable can be drawn
out from the top panel via the hole at the back.
• Check that the connection current corresponds
with the data on the serial number plate and
that the main circuit is correctly earthed in
compliance with applicable standards. We
recommend that the main circuit is fitted with
a residual current device.
• The manufacturer waives all responsibility if
the electrical connection is not made according
to the method set out in these operating
instructions.
Customer Care Center
1-800-898-1879
www.askousa.com
9