Asko DC7784HP.W.AU User Manual page 31

Questions
The display shows
CLOSE DOOR
The display shows
an alarm/error
code
Drying takes a long
time.
The washing does
not become dry.
The sealing strip
does not seal
tightly, the door is
ajar.
859149au_en.indd 31 859149au_en.indd 31
Action
1. Check that the door closes tightly so that the door switch
is activated. (Located at the bottom of the cabinet on the
cover plate in front of the heat pump unit).
2. If necessary, try to tape the switch in position and check
whether the warning on the display disappears.
3. If none of the above work contact Service.
This should normally not happen, but if an alarm or error
code appears, fi rst try to reset the alarm by holding the
Start/Stop button down for 5 sec.
If the problem persists, consult the error code list on page
33 to try to locate the fault. Try to rectify the indicated fault,
but if the fault persists the unit (the heat pump box) must be
replaced. Contact Service.
1. Clean the fi lter (this should preferably be done after each
drying operation).
2. Check that the water tank is empty.
3. Make sure that the correct program has been selected
for the type of washing.
4. Make sure that the washing is not soaking wet (poorly
spun).
5. Make sure that too much washing has not been hung up.
6. Adjust parameters P2072 and P2071 as described in the
chapter on OPTIMISING THE DRYING PROGRAM.
1. Make sure that the correct program has been selected
for the type of washing.
2. Make sure that too much washing has not been hung up.
3. Adjust parameters 2072 and 2071 as described in the
chapter OPTIMISING THE DRYING PROGRAM.
1. Check that the cabinet is level. Check with a spirit level,
adjust if necessary with the adjusting feet.
2. Check that the cleaning fi lter and its holder are correctly
fi tted. The holder must be pressed down against the
underlying heat pump unit and locked with the revolving
mounting brackets to seal properly.
3. Check that no litter, gravel or similar has ended up
beneath the holder of the cleaning fi lter, as the fi lter will
not seal satisfactorily if this is the case.
31
17. 02. 2022 08:51:31 17. 02. 2022 08:51:31