Honda EU30i Manual page 64

FRONT FRAME/CENTER FRAME/
HANDLE BASE REMOVAL/
INSTALLATION
Remove the following parts:
– Carry handle (page 5-2)
– Right shroud (page 5-8)
– Engine switch/control (page 6-10)
REAR GUARD BRACKET
REMOVAL / INSTALLATION:
Install the center frame, rear guard
bracket, and two 6 x 57 mm bolts to the
under cover.
Tighten the bolt securely.
BOLT (6 x 57 mm) (2)
CENTER FRAME
REAR GUARD
BRACKET
FAN COVER SEAL
TAPPING SCREW (5 x 16 mm) (2)
1.2 N·m (0.12 kgf·m, 0.9 lbf·ft)
CENTER FRAME / LEFT SHROUD
INSTALLATION:
Install the center frame by aligning the flange of the
left shroud with the groove of the front frame.
LEFT SHROUD
GROOVE
INSTALLATION:
Install the center frame/left shroud as shown.
CENTER FRAME
CENTER FRAME TAPE
FAN COVER SEAL
GROMMET
HARNESS BAND CLIP
FRONT FRAME
INSTALLATION:
Install the generator wire
harness and grommet to the
front frame hole as shown.
FRONT FRAME
GENARATOR WIRE HARNESS
SPECIAL BOLT (6 mm) (2)
COVER
GROMMET
HANDLE PIPE
HANDLE BASE
BOLT (6 x 35 mm) (2)
BOLT (6 x 20 mm)
GENARATOR
WIRE HARNESS
5-9