Honda EU30i Manual page 111

GENERATOR/CHARGING SYSTEM
CONTROL PANEL REMOVAL/
INSTALLATION
WITHOUT C TYPE
Remove the following parts:
– Side cover (page 5-7)
– Inverter unit (page 8-7)
12
GND1
BOLT (6 x 14 mm)
GENERATOR WIRE HARNESS TERMINAL
CONTROL WIRE HARNESS TERMINAL
REMOVAL/INSTALLATION:
Move the terminal as shown.
8-8
CONTROL PANEL
RECTIFIER
BOLT (6 x 14 mm)
CONTROL WIRE
HARNESS TERMINAL
GENERATOR WIRE
HARNESS TERMINAL
BOLT (6 x 57 mm) (2)
BOLT (6 x 10 mm) (2)
9.3 N·m (0.95 kgf·m,
6.9 lbf·ft)
TAPPING SCREW (5 x 16 mm) (2)
1.4 N·m (0.14 kgf·m, 1 lbf·ft)
ENGINE STOP SWITCH 2P CONNECTOR
REMOVAL/INSTALLATION:
Remove the engine stop switch as shown.
ENGINE STOP SWITCH
2P CONNECTOR