SATO D508 Service Manual page 86

Unit 5: Adjustment Procedures
PRINTER COUNTER CLEAR
This procedure clears the internal cycle counters of various components and returns their values
to zero.
1 Open the Top Cover and remove the front cover.
2 Set the DSW5 dip switch to the ON position.
NOTE: Refer to Figure 5-1 for visual assistance in performing this procedure.
3 Press and hold the LINE and FEED buttons while switching ON the printer.
4 Release the LINE and FEED buttons when a beep sounds.
5 Switch OFF the DSW5 dip switch and latch the Top Cover closed.
NOTE: When the Top Cover is closed, the clear process will automatically be
initialized. During the clear process, the printer will be in an offline state.
Press the LINE button to test print a large label and the FEED button to
test print a small label.
NOTE: Pressing the FEED button pauses test printing activity. Allow a
minimum of two labels to be printed before terminating to ensure the clear
process was successful.
CUTTER COUNTER CLEAR (IF CUTTER IS INSTALLED)
1 Open the Top Cover and remove the front cover.
2 Switch the DSW6 dip switch to the ON position.
NOTE: Refer to Figure 5-2 for visual assistance in performing this procedure.
3 Press and hold the LINE and FEED buttons while switching ON the printer.
4 Release the LINE and FEED buttons when a beep sounds.
5 Switch OFF the DSW6 dip switch and latch the Top Cover closed.
NOTE: When the Top Cover is closed, the clear process will automatically be
initialized. During the clear process, the printer will be in an offline state.
Press the LINE button to test print a large label and the FEED button to
test print a small label.
NOTE: Pressing the FEED button pauses test printing activity. Allow a
minimum of two labels to be printed before terminating to ensure the clear
process was successful.
Page 5-6 SATO D508/D512 Service Manual