Offsets - SATO D508 Service Manual

OFFSETS

There are two offset settings stored in the printer; one for the Cut mode and one for the Tear-Off
mode.
These two offsets can be set independently and will remain in the printer until a new command is
received changing the setting or until power is turned off.
The default settings can be determined by printing a User Test Label.
The following should be used as starting points for establishing the three Offset values:
Mode
CUTTER
TEAR-OFF
Page 1-15
Length of Offset (mm) Length of Offset (in) Print head resolution
17.9
29.2
0.70
1.15
SATO D508/D512 Service Manual
143/215
234/350