SATO D508 Service Manual page 83

Unit 5: Adjustment Procedures
FACTORY CLEAR
This procedure clears all data from the EEPROM. Once initialized and completed, the process
cannot be reversed.
1 Open the Top Cover and remove the front cover.
2 Switch ON the DSW5 and DSW6 dip switches.
NOTE: Refer to Figure 5-1 for visual assistance in performing this procedure.
3 Press and hold the LINE and FEED buttons while switching on the printer.
4 Release the LINE and FEED buttons when a beep sounds.
5 Switch OFF the DSW5 and DSW6 dip switches and latch the Top Cover closed.
NOTE: When the Top Cover is closed, the clear process will automatically be
initialized. During the clear process, the printer will be in an offline
state.Press the LINE button to test print a large label and the FEED button to
test print a small label.
NOTE: Press the LINE button to test print a large label and the FEED button
to test print a small label. Pressing the FEED button terminates printing
activity. Print at least two labels to ensure the clear process was successful.
SATO D508/D512 Service Manual Page 5-3