Duplex Printing Error Detection Setting - Kyocera EcoPro EP C170N User Manual

Setting the Error Clear Time

Duplex Printing Error Detection Setting

ADVANCED OPERATION GUIDE
5 Press [OK] ([ENTER]). A blinking question
mark (?) appears.
6 Select On or Off using
7 Press [OK] ([ENTER]).
8
To exit the menu selection, press [MENU]. The display returns to Ready.
1
Press [MENU].
2
Press or repeatedly until Others >
appears.
3
Press .
4 Press or repeatedly until >Auto
Error Clear > appears.
5 Press and display >>Error Clear
Timer. The default setting is 30 seconds.
6
Press [OK] ([ENTER]). A blinking cursor (_)
appears.
7
Press or to increase or decrease the value at the blinking cursor and
set the desired time. The time must be set between 000 and 495 seconds,
in 5-second increments. If set to 000, printing will be continued
immediately without any time interval. You can use
cursor right and left.
8
Display the desired time and press [OK] ([ENTER]).
9 Press [MENU]. The display returns to Ready.
If the error detection setting for duplex printing has been turned On, and
you attempt to print onto a paper size and paper type that cannot be used
for duplex printing, the Duplex disabled Press GO error message will
Using the Operator Panel
>Auto Error
Clear ? Off
or .
Others
>Auto Error
Clear
>>Error Clear
Timer
>>Error Clear
Timer
>
>
On
030sec.
030sec.
and to move the
2-85