Kyocera KM-2050 Basic Operation Manual page 35

4 Grasp the paper length adjusting tab and adjust the
length guide to the paper size.
Important!
• Make sure that the length guide is flush against
the paper. If there is space between the guide and
the paper, set the length guide again.
• When setting 11 × 17" (Ledger) paper, move the
paper length guide to the right end and push it
down as shown in the illustration.
Note
The paper sizes are impressed in the cassette.
5 Set the paper straight from the upper part.
Important!
• Be careful not to bend or crease the paper when
inserting it into the cassette. Creases in the paper
may lead to paper jams.
• The maximum paper limit indicator A is provided
on a paper width guide. Make sure that the paper
loaded is below the maximum paper limit indicator.
• When loading paper into the cassette, set it with
the side which faced the top of its packaging
facing up.
• Be sure to adjust the width and length guides to
the paper size before loading the paper. Failure to do so may result in paper skewing or
jamming.
• If the length and width guides are not flush against the paper, a size that is different from the
actual size may be displayed on the message display.
• When the paper has become wrinkled from moisture and cannot be fed, set the paper so that
the wrinkled side is toward the length guide.
Note
When loading paper into the cassette, set it with the side to be printed facing up.
Preparations
A
2-3