Interrupt Mode - Kyocera KM-2050 Basic Operation Manual

Interrupt Mode

The interrupt mode can be used to stop output of
copying or another job temporarily and to output urgent
copy or print data or received fax data. After the
interrupt processing is complete, the interrupted job
can be resumed.
The following modes are available for the interrupt function.
Mode
Interrupt copy
Priority output
During a Copy Job
1 Press the Interrupt key. Interrupt mode OK
[Interrupt mode] is displayed.
2 Store the originals for the current copying.
3 Set the original for interrupt copying and perform copying.
4
After the interrupt copying is complete, press the Interrupt key. The settings for the interrupted job
are restored.
5
Replace the original with the originals that have been stored. Press the Start key to resume
copying.
Description
• This mode can be used to stop copying and to make a copy of
a different original at different settings. After the interrupt copy
has been produced, the interrupted copying can be resumed at
the same settings in effect prior to the interruption.
• This mode can also be used to stop output of a job and to make
a copy of another job. After the interrupt copy has been
produced, the interrupted job is resumed.
This mode can be used to interrupt output of a job and to output
print data or received fax data with priority. After priority output is
complete, the interrupted job is resumed.
Note
To use the fax functions, the optional fax kit must be installed.
Basic Operation
3-21