Kyocera KM-2050 Basic Operation Manual page 113

Message
System error.
Main switch off / on.
RAM disk error Press GO
MemoryCard err Press GO
Memory card error Insert
again.
Insert same memory card
Format error Memory card
Print overrun Press GO.
Interface occupied
Checksum Error
(25 ppm model only)
Check the Toner Container.
Procedure
This message is displayed when a malfunction due to noise or the
like or a communication error during printer processing has occurred.
Follow the procedure below.
1 Turn the main power switch off ( ). If printer output is being
performed, cancel printing on the computer.
2 Wait more than five seconds and then turn the main power
switch on ( | ). The error is cleared. If printing has been
performed, perform output again.
An error has occurred in writing to or reading from the RAM disk.
Press the Printer key, select GO, and press the Enter key. The error
will be cleared.
An error has occurred in writing to or reading from the memory card.
Press the Printer key, select GO, and press the Enter key. The error
will be cleared.
The memory card is accidentally removed during printer setting.
Insert the memory card.
Note
When inserting the memory card, turn the main power switch off ( ).
When the machine has tried to read data from the memory card, it
cannot recognize the memory card.
Insert the memory card again.
Note
When inserting the memory card, turn the main power switch off ( ).
The memory card inserted in the machine must be formatted.
Format the memory card.
Printing has not been performed properly because of insufficient
memory.
Press the Printer key to display the following messages.
GO: Continues printing.
CANCEL: Cancels printing.
RESET: Resets the printer board. In this case, only the printer
functions will be reset.
Press the key or the
press the Enter key.
Notes
• If the auto continue setting has been turned On, printing will be
automatically resumed after a preset period of time.
• After this error message is displayed, the page protect mode will
be automatically turned On.
The selected interface is currently being used. Wait for a while and retry.
The machine has detected an error at startup.
Turn off the main power switch and on again. If the same message
appears, contact your service representative or authorized service
center.
The toner inside the container shifts to one side.
Refer to the procedures 16 and 17 on page 5-9 to turn the gear of the
toner container.
key to select the desired processing and
Troubleshooting
Reference
page
—
—
—
—
—
—
—
—
—
5-9
6-7