New Holland T8010 Manual page 93

All transmissions are full powershift transmission and controlled by the transmission controller. The standard
transmission has 18 forward speeds and 4 reverse speeds. There is an optional transmission with 19 forward
speeds and 4 reverse speeds. This transmission has 50Km/h roading capability. The optional creeper transmission
has 23 forward speeds and 6 reverse speeds.
It is not necessary to use the inching pedal when shifting between gears or in and out of neutral with a full
powershift transmission. The transmission is also equipped with an electro-hydraulically operated park brake
mechanism that is applied when power is removed.
The transmission controller either directly or through the Data Bus monitors the state/value of the following items:
The transmission controller will report any problems directly to the instrumentation cluster controller. The
instrumentation cluster controller will display any system faults or fault code information through the programmable
display.
When a fault occurs, a 3 second continuous audible alarm will sound. The audible alarm will stop after 3 seconds.
Once the fault has been corrected, depress the "Reset" button on the programmable display to clear the fault.
NOTE: The following warning is of a critical nature and the tractor engine should be shut down immediately and
the cause of the problem checked. If your tractor is equipped with the Performance Monitor, the tractor will
automatically shut down in 30 seconds after the warning is displayed. The warning below cannot be shut off by
pushing the reset button.
Display
OIL TEMP
The following faults will not cause immediate damage to the tractor or shut the tractor down, but may make other
systems inoperative. Pushing the "Reset" button will clear the fault however, the fault will be displayed again after
ten minutes if not corrected.
Section 21 - Transmission, Drivelines - Chapter 1
Transmission Control Lever
Gear Selection Switch
Bottom of Clutch Switch
Engine Speed Sensor
Transmission Speed Sensor
Description
TRANS High transmission oil
temperature
Display
TRANS
OFF LINE
TRANS
OFF LINE
TRANS
CONF/CAL
SIT
DOWN
Seat Switch
Corrective Action
Shut the tractor engine OFF immediately
and check for cause.
Description
Transmission Bus Off fault.
Transmission diagnostic fault.
TRCU - Config/CAL required (bit
in system status).
TRCU re-enable required.
21-1-4