Setting The End Play Of The Range Transmission Countershaft And Input Shaft - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

SETTING THE END PLAY OF THE RANGE TRANSMISSION

The end play of each shaft must be checked if any of

the following parts were replaced: shaft, front bearing

cage, bearing cones and cups, or front bearing

support cover.

Rotate the shaft a minimum of 12 revolutions. Use a

dial indicator to measure the end play. Use a prybar

inside the range transmission housing to lift a gear on

the shaft. The end play must be 0.025 to 0.127 mm

(0.001 to 0.005 inches) for the input shaft (2) and

0.013 to 0.102 mm (0.0005 to 0.004 inches) for the

countershaft (1).

If the end play is not within 0.025 to 0.127 mm (0.001

to 0.005 inches) for the input shaft, add or remove

shims to get a correct reading.

If the end play for the countershaft is not within 0.013

to 0.102 mm (0.0005 to 0.004 inches), add or remove

shims to get a correct reading.

NOTE: Check one shaft at a time.

Section 21 - Transmission, Drivelines - Chapter 6

COUNTERSHAFT AND INPUT SHAFT

Install the snap ring on the input shaft that positions

the master clutch.

Install the lubrication tube to the input shaft bearing

Chapters

Table of Contents

T8020 T8030 T8040