Suspended Fwd Axle- Demonstration Mode - New Holland T8010 Manual

SUSPENDED FWD AXLE - DEMONSTRATION MODE
IMPORTANT: The Electronic Service Tool (EST)
must be connected to the diagnostic port to get into
the Demonstration mode.
STEP 1
Push and hold the PROG key for two seconds within
the first ten seconds after starting the tractor. A short
beep will indicate that the program mode has been
accessed and the display will read CONFIG MENU.
STEP 2
Push the DECR key until Transmission is highlighted.
Press the PROG key.
Section 25 - Four-Wheel Drive Front Axle - Chapter 5
RD06A021
RD06A022
25-5-16
STEP 3
The display will read TRANS VIEW.
STEP 4
Push the DECR key until the display reads TRANS
FSUS.
STEP 5
Press the PROG key and the display reads Fsus Cal.
RD06A023
RD06A024
RD06A025