Table of Contents
Advertisement
(V1113H-V1123H) with sheet metal screws.
10. Install Jacket Side Panels
a. Snap black thumb hole bushings into all side
panel holes.
b. Use left side panel and right side panel usage
charts to determine correct positions of side
panels. The five (5) digit panel identification
numbers shown in the charts are also stamped
along the bottom edge of each panel. Refer to
Figures 24 and 25.
c. Forward and auxiliary panels have reverse bend
flanges on one side of panel. These panels must
be installed prior to rearward panels.
d. If boiler is equipped with tankless heaters they
should be installed at this time if they were not
installed for hydrostatic test outlined on Page 23.
e. Install left side panels into position by inserting
top of panel into upper 'U' channel, pushing
bottom of panel in toward boiler, and sliding
panel down into bottom 'J' channel.
f. Remove the knockouts necessary for tankless
heater operation on right side panels.
g. Install right side panels.
11. Combination Label and Burnham Commercial Logo
Figure 27: Burner Mounting Plate/Burner Adapter Plate Options
Figure 26: Burner Mounting Plate and Burner
Adapter Plate
31
Advertisement
Table of Contents
