Print Photos From A Camera; Print Photos From The Control Panel - Kodak EasyShare 5300 User Manual

Chapter 4
Two-sided Printing
You can print on both sides of the paper.
Watermark
You can select or create a background watermark.

Print Photos from a Camera

Connect your camera to the EasyShare AiO. The PictBridge logo is displayed on the LCD.
1
Load the photo tray with photo paper (See Load Photo Tray in Chapter 3).
2
Use your camera to select and print photos.
3

Print Photos from the Control Panel

The Photo Print mode is initiated by pressing the Photo button, inserting a memory card, or connecting a
USB device to the Kodak EasyShare All-in-One.
Insert a memory card into the appropriate slot, a mass storage device into the USB port, or connect a
1
digital camera to the USB port. The last photo is displayed.
WARNING
Never attempt to remove a memory card while it is being accessed. Doing so can damage
files on the card. You can safely remove a card only when the status light next to the slots is
not blinking.
Load the main tray (see Load Main Tray in Chapter 3) or photo tray (See Load Photo Tray in Chapter 3)
2
with photo paper.
NOTE: The Photo Tray only supports 4x6 inch and 100x150 mm photo paper.
Press to select the number of prints for this photo.
3
Press to preview the next photo.
4
TIP: To select all the photos on a memory card or mass storage device, hold down the OK button for 2
seconds. Holding down the OK button again for 2 seconds will de-select all the photos.
Repeat Steps 3 and 4 until you are finished selecting photos.
5
Press Start to print the selected photos or Photo to set print options.
6
Set print options.
7
See Set Print Layout
See Set Number of Prints
See Set Color
See Set Print Quality
After a photo is printed, it is de-selected.
38 Kodak EasyShare 5300 AiO