Dell Studio 1745 Service Manual page 35

Back to Contents Page
Media Controls Board
Dell Studio™ 1745/1747 Service Manual
Removing the Media Controls Board
Replacing the Media Controls Board
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
computer.
Removing the Media Controls Board
1. Follow the procedures in
2. Remove the battery (see
3. Remove the center control cover (see
4. Remove the keyboard (see
5. Remove the three screws that secure the media controls board to the computer base.
6. Lift the connector latch to release the media controls board cable from the media controls board cable connector on the system board.
7. Lift the media controls board off the computer base.
1 screws (3)
3 media controls board cable connector
Replacing the Media Controls Board
1. Follow the procedures in
2. Align the screw holes on the media controls board with the holes on the computer base.
3. Replace the three screws that secure the media controls board to the computer base.
4. Slide the media controls board cable into the media controls board cable connector on the system board and press down on the connector latch to
secure the cable to the connector.
5. Replace the keyboard (see
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
To help prevent damage to the system board, remove the main battery (see
Before You Begin.
Removing the Battery).
Removing the Center Control
Removing the Keyboard).
2 media controls board
Before You Begin.
Replacing the Keyboard).
UserManuals.info
Removing the Battery) before working inside the
Cover).