Processor Heat Sink - Dell Studio 1745 Service Manual

Back to Contents Page
Processor Heat Sink
Dell Studio™ 1745/1747 Service Manual
Central Processor Heat Sink
Graphic Processor Heat Sink
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
heat sink.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
computer.
Central Processor Heat Sink
Removing the Central Processor Heat Sink
1. Follow the instructions in
2. Remove the battery (see
3. Follow the instructions from
4. In sequential order (indicated on the processor heat sink), loosen the four captive screws that secure the processor heat sink to the system board.
5. Lift the central processor heat sink off the system board.
1 captive screws (4)
Replacing the Central Processor Heat Sink
NOTE: This procedure assumes that you have already removed the central processor heat sink and are ready to replace it.
1. Follow the procedures in
2. Place the central processor heat sink on the system board.
3. Align the four captive screws on the central processor heat sink with the screw holes on the system board and tighten the screws in sequential order
(indicated on the processor heat sink).
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
If you remove the processor heat sink from the computer when the heat sink is hot, do not touch the metal housing of the processor
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
To help prevent damage to the system board, remove the main battery (see
Before You Begin.
Removing the Battery).
step 2 to step 20 in Removing the System
2 central processor heat sink
Before You Begin.
UserManuals.info
Removing the Battery) before working inside the
Board.