__________________________________________________________________
It is not necessary to remove all of the grease from the output gear, only
the excess grease. Do not use solvents to clean the output gear.
1. Remove each servo.
2. Remove excess grease build‐up from the single servo output gear using a lint‐free cloth.
3. Apply a thin coat of grease to the servo output gear using a brush or other applicator (see
note above).
4. Reinstall the servos.
5. Rotate control surfaces through their range of motion to ensure freedom of movement.
9.6 GDC RVSM ALTITUDE INSPECTION
Operation with the GDC at RVSM altitudes requires an accuracy inspection every 12 months.
Refer to the GDC Field Calibration Tool Instructions if recalibration is required. The table below
provides the criteria and associated action for altitude inspection.
Inspection Pressure‐Altitude
(ft)
29,000
35,000
41,000
Cirrus Perspective™ Line Maintenance Manual
190-00920-00
Table 9‐1. GDC RVSM Altitude Inspection Criteria
Error, |x| (ft) at Inspection Action for Associated Error
40 < x ≤ 120
40 < x ≤ 120
40 < x ≤ 120
NOTE
x ≤ 40
No Action
Use Field Calibration Tool
120 < x
Replace Unit
x ≤ 40
No Action
Use Field Calibration Tool
120 < x
Return Unit to Garmin
x ≤ 40
No Action
Use Field Calibration Tool
120 < x
Return Unit to Garmin
Page 9-3
Rev. E