Hitachi GR4000 Series Quick Start Manual page 67

(2) Input configuration information.
Set the interface mode to 8k.
GR1(config)# system interface_mode 8k
!GR1(config)#
NOTE The mark "!" will be shown at the beginning of a prompt if you change configuration information.
However, you can delete this mark by saving configuration information you changed.
(3) Check the contents of configuration information you set.
Check the interface mode you set by displaying configuration information.
!GR1(config)# show system
system name "GR1"
system interface_mode 8k
!GR1(config)#
(4) Save the information you set.
Save the configuration information you set.
save
!GR1(config)#
GR1(config)#
NOTE The mark "!" at the beginning of a prompt can be deleted by saving configuration information.
(5) Exit the edit mode.
Exit the edit mode of configuration information.
exit
GR1(config)#
GR1#
QSGGR4K00-10 5794047-1X
...Set an interface mode.
...Show system information.
Display of system information
...Save configuration information.
...Exit the edit mode of configuration information.
GR4000 Quick Start Guide, Revision 1 - Preliminary
51