Hitachi GR4000 Series Quick Start Manual page 31

3.
Procedure
Connect a setup terminal to GR4000-160E2.
1．
Connect a setup terminal to the CONSOLE port of BCU (BCU0) using a RS－232C cross cable.
2．
Start up a setup terminal.
3．
Start up communication software
NOTE GR4000-160E2 is pre-configured in a way that a setup terminal can be connected to a
CONSOLE port of BCU0 when it is shipped from the factory. Connect a setup terminal to a
CONSOLE port of BCU0 in case that a basic control unit is redundant.
NOTE As for the setup of communication software, see the communication software manual.
4.
Procedure
Attach an interface cable.
Attach an interface cable to a interface port.
5.
Procedure
Power on GR4000-160E2.
Set all the breakers of GR4000-160E2 to ON. GR4000-160E2 has breakers on its backside.
6.
Procedure
Check LED.
When BCU0 LED of the front panel of GR4000 is lit in green, it means that GR4000 is started up.
Regarding the process GR4000 goes through until it starts up, see the section "2.2 Other Preparations".
NOTE When BCU0 LED or BCU1 LED is lit in red, it means that GR4000 is in trouble. For detail
information related to troubles, see GR4000 Software Manual Operations - Device Management
Overview and GR4000 Software Manual Message Log Reference.
●Slot number
The slot number for each option component (BCU number, PRU number and NIF number) of GR4000-160E2
is shown in the figure below.
Front panel
Packet routing unit
(PRU)
Network interface
board (NIF)
Slot numbers of GR4000-160E2
Figure 2-8
NOTE When using a nework interface board, it should be mounted into a packet routing unit.
NOTE There are two types of interface boards, which are single size and double size ones.
The number shown with "*" in the figure above is used for double size network interface boards.
QSGGR4K00-10 5794047-1X
GR4000 Quick Start Guide, Revision 1 - Preliminary
*
NIF7 NIF6
*
NIF4
NIF5
BCU1
BCU0
*
NIF2
NIF3
*
NIF0
NIF1
PRU3
PRU2
Basic control unit
(BCU)
PRU1
PRU0
15