Hitachi GR4000 Series Quick Start Manual page 44

GR4000 Quick Start Guide, Revision 1 - Preliminary
（A password is not set for administrators at the time of initial system introduction.）
enable
>
#
(4) Set a password of administrator.
Set a password of administrato.
# password
Changing local password for admin.
New password: ********
Retype new password:
passwd: updating passwd database
passwd: done
#
NOTE You must use a password consisting of 6 to 128 texts including some figures/special characters.
You cannot use a password consisting of only alphabets.
28
...Input
...Input
...Input a password of administrator.
(The password you input will not be shown.)
********
"enable" command.
"password" command.
...Input the same password again for confirmation.
QSGGR4K00-10 5794047-1X