Case Of Using The Network Interface Board Ne100-48T - Hitachi GR4000 Series Quick Start Manual

GR4000 Quick Start Guide, Revision 1 - Preliminary

6.2 Case of Using the Network Interface Board NE100-48T

GR4000 has the two types of interface modes（8k interface mode/16k interface mode）, and it is set to 16k as a default. When
using NE100-48T, you must set it to 8k . Setting the interface mode should be done through the following procedures.
NOTE For details about interface modes, see the GR4000 Software Manual Configuration Commands
CLI-CLI Type 1 Hierarchical Input Format, Vol. 1.
(1) Enter the edit mode of configuration information.
Enter the edit mode of configuration information according to the following procedures.（Skip to the section "(2) Edit
Configuration Information" in case that you've already entered the edit mode.）
BSDI BSD/OS 3.1
login: newuser
********
password:
All Rights Reserved,Copyright(C)2003,Hitachi,Ltd.
*** Welcome to the System ***
enable
GR1>
********
password:
configure
GR1#
GR1(config)#
NOTE After entering the edit mode of configuration definition, a configuration information file will be
opened automatically. Note that the example above is for the case where an active configuration
information file on memory is opened. You can open a designated spare file for configuration
information by inputting a file name after the "configure file" command.
For details about a spare configuration information file, see the GR4000 Software Manual
Configuration Settings CLI-CLI Type 1 Hierarchical Input Format-.
NOTE A device name you input will be shown at the beginning of a prompt.
50
...Input a user
ID.
...Input a login password.
...Register yourself as an administrator of GR4000.
...Input your password as an administrator.
...Enter the edit mode of configuration information.
QSGGR4K00-10 5794047-1X