Sony Trinitron PVM-20M7MDE Instructions Manual page 12

EXT SYNC OUT (external sync output) connector
(BNC-type)
Loop-through output of the EXT SYNC IN connector.
Connect to the external sync input connector on video
equipment to be synchronized with this monitor.
When the cable is connected to this connector, the 75-
ohm input termination is released, and the signal input
to the EXT SYNC IN connector is output from this
connector.
For detailed information on settings, see "To select the
signal to be monitored through the RGB/COMPONENT
connectors" on page 22.
5 REMOTE connector RS-232C (D-sub 9-pin)
Connect to the RS-232C control connector on a
personal computer. You can operate the monitor with
the commands from the computer.
For detailed information, refer to the supplied "Interface
Manual for Programmers".
For pin assignments of the REMOTE connector, see
"RS-232C connector (D-sub 9-pin)" on page 31.
6 RGB/COMPONENT B connectors
Input connectors for the R/G/B signals or component
signals, external sync signals and audio signals.
To monitor the input signal fed through these
connectors, press the RGB/COMPONENT B button on
the front panel. Then, select one of the four items RGB
-EXT SYNC, RGB -SYNC ON G, COMP -EXT
SYNC or COMP -SYNC ON Y on the RGB SYSTEM
-RGB B- menu.
For detailed information on settings, see "To select the
signal to be monitored through the RGB/COMPONENT
connectors" on page 22.
R/G/B IN or R-Y/Y/B-Y IN (input) connectors
(BNC-type)
When RGB -SYNC ON G or COMP -SYNC ON Y is
selected on the RGB SYSTEM -RGB B- menu, the
monitor operates on a sync signal from the G/Y
channel.
When RGB -EXT SYNC or COMP -EXT SYNC is
selected on the RGB SYSTEM -RGB B- menu, the
monitor operates on the external sync signal.
To monitor the analog RGB signal: Connect to the
analog RGB output connectors on a video camera,
VCR or other video equipment.
To monitor the component signal: Connect to the R-
Y/Y/B-Y component output connectors on video
equipment.
AUDIO IN (input) connector (phono jack)
Connect to the audio output connectors on video
equipment when the analog RGB or component signal
is input.
EXT SYNC IN (external sync input) connector
(BNC-type)
Connect to the sync signal output on a video camera,
VCR or other video equipment, when this monitor
operates on an external sync signal.
To use the sync signal fed through this connector,
select RGB -EXT SYNC or COMP -EXT SYNC on
the RGB SYSTEM -RGB B- menu.
7 1/YGround terminal
1:Equipotential terminal
Connect to the equipotential plug to bring the various
parts of a system to the same potential.
Y:Functional earth
See "Symbols on the unit" on page 4.
13