Replace Electronics Cover - Graco D60 Operation

Replace Electronics Cover

Removal
1. Perform the Pressure Relief Procedure, page 14.
2. Disconnect the unit from the power source.
3. Remove the lower from the driver. See Remove
Driver on page 35.
NOTE: This is required to complete the calibration pro-
cedure (page 29).
4. Remove two screws (6) and remove the junction
box cover (5).
F . 25: Junction Box Cover
IG
5. Loosen the cord screws on the disconnect block
(51) and disconnect the wires from locations 1L1
and 5L3.
NOTE: Power cord cables (excluding the ground wire)
may remain attached.
3A5379B
51
BA
6
6. Unscrew the ground screws from the fan and power
cord ground wires.
F . 26: Ground Screw Location
IG
7. Use a wire cutter to cut ferrule tips from the fan
wires and motor power wires.
NOTE: Cut the wires as close to the ferrules as possi-
ble. Do not cut the tip off of the ground wires.
F . 27: Disconnect Fan Wires
IG
8. Use an adjustable wrench to loosen the fan cord
grip (C1).
C1
F . 28: Loosen Cord Grip
IG
9. Pull the fan wires out through the cord grip.
Repair
27